Print Logo Dad Hat

A print logo dad hat is a hat with a printed or logo design added to the dad hat. The dad hat, also known as a duckbill cap or baseball cap, features a forward-extending visor that blocks the sun and protects the face from UV damage.

Reshaping a print logo dad hat is an activity that requires patience.

Tools and materials

Choose a small spray bottle with fine and even water output to humidify the hat moderately to prevent excessive moisture from deforming the hat and making it difficult to recover.

Soft hairpins or clips: Use soft clips so that the hat fabric or printed logo will not be damaged. The specific number should be prepared according to the size of the hat.

Clean cloth or paper towel: Mainly used for the final wiping and finishing of the print logo dad hat, choose a soft and absorbent material.

If you have a special shaping rack for hats, it is the best and very suitable for reshaping the hat.

Specific steps:

1. Preliminary evaluation and preparation:

First, observe the current shape of the hat and determine the parts that need to be adjusted. Then make sure the operating environment is clean and ventilated to avoid dust and moisture affecting the reshaping of the hat.

2. Moderate humidification:

Use a small spray bottle and gently spray a few times at a certain distance from the part of the hat that needs to be corrected to ensure that the surface of the print logo dad hat is evenly covered with a thin mist of water. Note: Spray water in moderation, do not form water droplets or make the hat too wet!

3. Carefully adjust the shape:

Gently pinch the edges and top of the hat with your hands and adjust it according to the original shape. If the hat is creased or uneven, use the belly of your finger to gently smooth it out, and pay attention to moderate force to avoid damaging the printed logo or fabric. Too much force can easily damage the surface of the print logo dad hat, and too little force cannot achieve the desired effect.

4. Fix the shape:

Use soft hairpins or clips to fix different parts from the inside of the hat. The clips are evenly distributed and not concentrated on a certain point, so that the print logo dad hat will have a balanced shape after drying, and there will be no inconsistency and reshaping.

If a special shaping rack for hats is used, it can be placed inside the hat to provide better support and shaping effect for the hat.

5. The art of natural drying

Put your hat in a well-ventilated place away from direct sunlight and let it dry quietly and naturally. Or put it in the shade, or use the breeze of a fan to help it dry faster. However, never use a hair dryer or any heat source to speed up the drying process, as the heat may damage the fabric or printed logo of the hat.

6. Final meticulous finishing

Once the print logo dad hat is completely dry, you can remove the clips that fix the shape. Do not use brute force to remove the clips, which will cause damage to the hat. Next, use a clean cloth or paper towel to gently wipe the surface of the hat to remove any water stains or dust that may be left.

Then you need to look at your work with a critical eye, checking whether the shape of the hat is perfect and whether the printed logo is still bright and intact. If you find any unsatisfactory areas, follow the previous steps again and make fine adjustments until you are satisfied.

Finally, use a soft brush to gently and carefully brush away the fine dust and hair that may remain on the surface of the hat, so that your hat will be refreshed and clean as before.

7. Precautions

During the operation, be gentle and patient. Excessive force will cause the print logo dad hat to deform more seriously or damage the printed logo.

Check the shape and fixation of the hat regularly to ensure that it maintains the ideal shape during the drying process.